Page 1 of 1
Redzook - cut off rockers ?
Posted: Fri Jul 22, 2005 11:21 pm
by bubs
In the zook forum rigs thread you mentioned cut off rockers got any pics of what you mean?
I was planning on trimming my rockers off about an 1inch below the door but i would be a pita the join it all back to gether, so what did you do?
Posted: Fri Jul 22, 2005 11:35 pm
by bubs
dont worry answered my own question
Posted: Sat Jul 23, 2005 3:26 am
by lay80n
Buddy, look at Rhetts rockers too, he has 45'd his, look good nad more functional too (excuse pissed posting, hope this helps
)
Layto....
Posted: Sat Jul 23, 2005 7:40 am
by redzook
bubs wrote:dont worry answered my own question
i didnt worry about plating it back up
because i cut into my footwell too
(i have 3 bars to my sliders the front one actually comes into my footwell
)
just so i could get the first stay of the slider straight = more clearance
Posted: Sat Jul 23, 2005 3:49 pm
by Rhett
45ed sills, they still bend when you land on them hard. mine are 4mm thick with 50mm returns on both corners. Im going to buil a bash plate that contiues up from the chassie rails to the sills like boat sides.
Posted: Fri Jul 29, 2005 4:31 pm
by markil
Rhett wrote:45ed sills, they still bend when you land on them hard. mine are 4mm thick with 50mm returns on both corners. Im going to buil a bash plate that contiues up from the chassie rails to the sills like boat sides.
I'd like to see some more pics of your sills and a bit more explanation on how and where exactly you cut and welded everything. Could you post some more info and pics up please?
I'm just about to do mine and not exactly sure how to go abouts doing it.
Mark.