Page 1 of 1
ARB bar lift for BL
Posted: Fri Sep 02, 2005 12:33 pm
by nicbeer
Hey,
How have people lifted their ARB bar for a 2" bodylift.
On a zook, it has finger like steel attachments for the chassis, as attached.
The top section goes on the outside of the chassis and the bottom bit is in the inside the chassis rail.
this is the same on both sides.
Any ideas
cheers
Posted: Fri Sep 02, 2005 2:30 pm
by dumbdunce
chop chop weld weld, it's the only way.
Posted: Fri Sep 02, 2005 2:44 pm
by nicbeer
dumbdunce wrote:chop chop weld weld, it's the only way.
Thought that might be the way. i will do the BL first and then have a play with that.
cheers
Posted: Tue Sep 06, 2005 6:31 pm
by GQ4.8coilcab
just drill the holes down to your BL height. If you cant drill the bottom one down any more, weld a bit of flat plate on. I know that works for a GQ TJM bar.
Posted: Tue Sep 06, 2005 7:19 pm
by Fathillbilly
dumbdunce wrote:chop chop weld weld, it's the only way.
i used to work under a crazy swiss engineer that used to say this all the time, he would stand there with a ferrel smoke that just stunk (i smoke)
and stand there puff after puff thinking about how to fix the problem then while pointing with his smoke he would say "cut cut weld weld" in a very thick accent, the thing is he would never actually point at anything we were working on, and i dont think i herd him say any thing else.
the things you have to go through when you are working on a mine site
Stu