Hi Guys
Got 93 td42 Patrol. Noticed on starting from cold engine would chug for 4 or 5 turns before starting after heat plug light went out. Unusual I thought as it normally bangs into life second turn. I had 6 new NGK plugs on hand so fitted them.....bugger still done the same on me this morning. So if glow plug relay was faulty would plug light on dash go out as normal. I thought light was going out rather quick.Is there a fusible link and or another fuse in the footwell somewhere.When taking the plastic screw cap off the old heater plug there was only a small spring washer on the thread part of the plug. With new plugs there is spring washer plain washer and small hex nut. Do you use any of the supplied stuff on Patrol application? I will check battery also but engine is turning quickly. I have meter but don`t know which setting to put it on to check power at glowplug and bar strip. Any help appreciated.
Alex
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
slow starting
Set it to measure DV voltage.
Is it a Digital one or a dial one??
Set the dial one to measure up to DC 50V
If you set it to less the needle will just shoot over to the far side of the gauge and you won't get an accurate reading.
You should get 12V between the top of the plug and any where on the connector strip between the plugs and the block/head.
Get some one to sit in the car, set up the probe's on the voltmeter between the block/head and were ever you choose to measure on the glow plug circut and then get you helper to turn the key.
You should see the needle jump to around 12V and then when the light goes off in side, the voltage should either drop or dissappear.
Individual glow plugs can be tested out of the vehicle using a battery, conect the threaded portion to the negative terminal and the bit where the connector strip would attach to the positive. Do not hold in your hand, vice grips are of poly grips are good.
Is it a Digital one or a dial one??
Set the dial one to measure up to DC 50V
If you set it to less the needle will just shoot over to the far side of the gauge and you won't get an accurate reading.
You should get 12V between the top of the plug and any where on the connector strip between the plugs and the block/head.
Get some one to sit in the car, set up the probe's on the voltmeter between the block/head and were ever you choose to measure on the glow plug circut and then get you helper to turn the key.
You should see the needle jump to around 12V and then when the light goes off in side, the voltage should either drop or dissappear.
Individual glow plugs can be tested out of the vehicle using a battery, conect the threaded portion to the negative terminal and the bit where the connector strip would attach to the positive. Do not hold in your hand, vice grips are of poly grips are good.
Who is online
Users browsing this forum: No registered users and 3 guests