I have GU patrol with the factory bullbar. Until half an hour ago it had a XD9000 winch fitted to it. I decided that the high mount sitting in my garage would fill the gap better so ripped out the low mount and started measuring. From my measurements, Although tight, the highmount should fit in the gap and bolt up to the original low mount bolt holes. The only problem is the low mount was mounted upside down so the cable ran over the top of the drum, The highmount runs underneath. Can the highmount be set up to run the cable over the top of the drum?, so I don't have to get out the plasma cutter and mig to make it fit.
Bob
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Warn Winch Question
Moderators: toaddog, TWISTY, V8Patrol, Moderators
Who is online
Users browsing this forum: No registered users and 3 guests