Outer Limits 4x4 Board

OK, so recently I had my gearbox and clutch replaced due to years of abuse. Whilst this was being done a water leak was spotted at the back of the engine area (which was fixed at the time).

Anyhow, I got my car back yesterday, and for some reason the following does not work:
- Speedo
- Water temp gauge
- green 4wd light

The tacho works fine, and same with the indicators and warning light.

My question is are the above 3 related in anyway? Anything obvious I should look for? has this happened to anyone else?

Thanks guys!

Speedo- check the cable from the gearbox is still connected. Same for the water temp sender- I think it's near the back of the engine somewhere?

I'm not sure where the 4WD light switch is? I know mine is sometimes a bit hesitant to come on!

sounds to me that the guys who did the clutch forgot to put things back where they came from.
as said before the speedo is a cable that goes into the gearbox or transfer case depending on the vehicle, the temp sender is a wire that goes on a terminal either on the block or thermostat housing area, 4wd switch will be a wire on the transfer case near the top.
personally i would be going back and having a few words to the so called mechanic that did the clutch

Thanks guys..appreciated!!

Speedo and Thermo gauge are now working perfectly!

My 4wd light is still refusing to work though. Might clean the terminals on the transfer case