Due to a careless wrecker ripping out the old drivers seat with a crowbar it has ripped the welded nuts on the rear drivers seat mount through the mount and looking a bit like a mess.
I was going to get some 70-75mm RHS or channnel and box the original units in and weld them up. then use a new bolt + nut/nyloc or weld new nut on underneath for seat bolting.
i was thinking of getting some 3mm wall for this as the orig is paper thin.
thanks
Nic
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Seat mount fix??
Seat mount fix??
[url=http://www.outerlimits4x4.com/viewtopic.php?p=930942#930942&highlight=]Zook[/url]
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
U SUK Zook Built and Sold.
New rig is 97 80 DX. 2" list 33s
Who is online
Users browsing this forum: No registered users and 0 guests