Seat mount fix??
Posted: Wed Nov 23, 2005 2:38 pm
Due to a careless wrecker ripping out the old drivers seat with a crowbar it has ripped the welded nuts on the rear drivers seat mount through the mount and looking a bit like a mess.
I was going to get some 70-75mm RHS or channnel and box the original units in and weld them up. then use a new bolt + nut/nyloc or weld new nut on underneath for seat bolting.
i was thinking of getting some 3mm wall for this as the orig is paper thin.
thanks
Nic
I was going to get some 70-75mm RHS or channnel and box the original units in and weld them up. then use a new bolt + nut/nyloc or weld new nut on underneath for seat bolting.
i was thinking of getting some 3mm wall for this as the orig is paper thin.
thanks
Nic