Page 1 of 1
GQ Trasfer Case Bearing and seal kit ??
Posted: Mon Dec 05, 2005 8:43 am
by Draven
Hey Guys,
Ive just got myself some crawler gears, and would like to replace any bearings / seals in the transfer while im at it. I was just wondering if anyone has done this and where they got it from ? Is there a 'kit' i can buy with everything i need in it ?
Any ideas would be greatly appreciated.
Thanks
Re: GQ Trasfer Case Bearing and seal kit ??
Posted: Mon Dec 05, 2005 9:26 am
by bogged
Draven wrote:Hey Guys,
Ive just got myself some crawler gears, and would like to replace any bearings / seals in the transfer while im at it. I was just wondering if anyone has done this and where they got it from ? Is there a 'kit' i can buy with everything i need in it ?
Any ideas would be greatly appreciated.
Thanks
have a search. Wendle listed all the bearing numbers for me once in the past.
Posted: Mon Dec 05, 2005 10:02 am
by Draven
arr after much searching i found the part no's..
For anyone else heres the copy of the copy of the post
Taken from Wendle's write-up. I'm not taking credit for this. Just so happened that I was looking back at page 101 and found the page so I copied it for you.
Cheers
Anyone planning on ever re-buidling a Nissan T/Case for different gears or whatever, cut & paste this so you can buy all the shit before you start.
I got oil in my eye holding one of the seals up to the light to read the miniscule numbers off of it, so be grateful The Finger
Don't bother with Nissan, they won't sell the individual bearings to anyone off the street, only a full t-case reco kit ($)
Bearings:
6212NC3 (NTN)
6208C3 (NTN)
TM207 (NSK)
6306 (2x) (NTN)
6208ZC3 (NTN)
6213Z (NSK)
Seals:
15 Z 50 72 12 AE (Input)
15 Z 50 72.5 19.5 AE (Rear output)
15 Z 40 75 17.9 AE (Front output)
EDIT: Had the rear output diameter wrong. changed from 60mm to 50mm
Posted: Mon Dec 05, 2005 10:03 am
by Draven
Just curious bogged, i read that you were going to get someone else to install the crawler gears for you. Would you be able to recommend them ?
Thanks
Posted: Mon Dec 05, 2005 10:49 am
by bogged
Draven wrote:Just curious bogged, i read that you were going to get someone else to install the crawler gears for you. Would you be able to recommend them ?
I dont have them ... after talking to several people, I thought against it.
Normal low range is reallly useful for some areas I travel, and LOW low would be annoying - revving going nowhere FAWKIN SLOWLY.
Posted: Mon Dec 05, 2005 10:51 am
by bogged
Draven wrote:Just so happened that I was looking back at page 101 and found the page so I copied it for you.
its on page 1 of the bible if ya look