Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

New Bellhousing for VH45 conversion

Tech Talk for Nissan owners.

Moderators: toaddog, V8Patrol

Forum rules
Post Reply
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

New Bellhousing for VH45 conversion

Post by bogged »

Eric asked me to post this..

Well not new, but reconditioned...

This is from Ptrool, and is almost factory.
You do not have the required permissions to view the files attached to this post.
Top
Posts: 3189
Joined: Thu Mar 04, 2004 1:11 pm
Location: Jimboomba

Post by BIG GQ »

And what do you want? Comments? Offers? :roll: :finger: :finger: :finger: :D :D :D
Cheers
Linc

[quote="chimpboy"]Punctuation is the difference between 'I helped my Uncle Jack off his horse' and 'I helped my uncle jack off his horse.'[/quote]
Top
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

BIG GQ wrote:And what do you want? Comments? Offers? :roll: :finger: :finger: :finger: :D :D :D
nfi, some people asked to see what he had done, and how.. so for them, and not you :P here it is
Top
Posts: 68
Joined: Sun Aug 17, 2003 10:32 pm
Location: Melbourne

Contact:
Contact Eric

Post by Eric »

Sorry Big GQ , should have replied earlier , a few people on here were asking questions about the belhousing I was going to use , and if i could post a pic when it was finished . The original bell housing made, looked like a bit of a scolpture and eye saw , but the measurment wernt to bad , so desided to re work it. After a lot of welding and reworking , this what i came up with , also front to rear surfaces were not flush , but a couple of runs through the mill soon fixed that .

Unfortuantly I don't get much time to work on PTROOL , but I am in no rush to finish it . I am emailing Bogged all the step by step pic's and he will put them up on a web page for me .
Top
Posts: 45681
Joined: Wed Nov 27, 2002 10:13 am

Post by bogged »

Eric wrote:Sorry Big GQ , should have replied earlier , a few people on here were asking questions about the belhousing I was going to use , and if i could post a pic when it was finished . The original bell housing made, looked like a bit of a scolpture and eye saw , but the measurment wernt to bad , so desided to re work it. After a lot of welding and reworking , this what i came up with , also front to rear surfaces were not flush , but a couple of runs through the mill soon fixed that .

Unfortuantly I don't get much time to work on PTROOL , but I am in no rush to finish it . I am emailing Bogged all the step by step pic's and he will put them up on a web page for me .
I think its pretty impressive for a home made jobby! Wish I had that sorta talent and tools
Top
Post Reply

Return to “Nissan”

Who is online

Users browsing this forum: No registered users and 2 guests