Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Pulling a ball joint

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Forum rules
Post Reply
Posts: 249
Joined: Mon May 26, 2003 9:37 pm
Location: brisbane

Pulling a ball joint

Post by greenhilux »

I need to pull the ball jints in my 2000 lux. I have a bal joint puller, but as yet cannot fathom how it works without raping the rubber boots. Copuld some please explain this to me, pref with a picture, it would be much appreciated.

Mark.
Top
Posts: 3224
Joined: Mon Jan 12, 2004 6:03 pm
Location: Moggill

Post by phippsy »

I'm only guessing but I would have thought that needing a ball joint puller you'd replace the joints anyway. The only other way I've done it ages ago was to put a chock under that arm the ball joint was in, leave the nut on the thread and give a good sharp hit. May not be the best way but at the time it worked a treat.
Top
Posts: 249
Joined: Mon May 26, 2003 9:37 pm
Location: brisbane

Post by greenhilux »

i've got a ball joint puller, the one with the prong and the screw, just wondering where exactly to place it in order to save the joint and boot.
Top
Posts: 3349
Joined: Tue Nov 23, 2004 10:29 am
Location: Not where you are

Contact:
Contact Gribble

Post by Gribble »

Have you tried the twin hammers method yet?
\m/
Top
Post Reply

Return to “General Tech”

Who is online

Users browsing this forum: No registered users and 4 guests