I just purchased a 60series 2F that is going into a 40 Series which has a 2F and 4spd.
A few questions
Is the input shaft on the 4spd the same size as the bush on the 60 series 2F?
Is the clutch the same as the 40 series? will i be able to bolt the bellhousing, clutch etc straight to the 40 series 4spd?
thanks.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
2F Clutch
Moderators: toaddog, Elmo, DUDELUX
2f clutch
Last christmas I fitted a 2f out of a 60 series into a 1973 f 4 speed 40 series. the input shaft is the same, 10 spline, no problem. A 2f 4speed should be the same in a 60 or a 40.
My problem was, I didnt get the rear engine mounts and r/h clutch slave cylinder with the motor. So I had to swap over the origional f bellhousing with the l/h clutch slave and engine mounts. the whole lot bolted up ok, 60 series 2f to '73 bellhousing, clutch and gearbox. It should all bolt up ok.
My problem was, I didnt get the rear engine mounts and r/h clutch slave cylinder with the motor. So I had to swap over the origional f bellhousing with the l/h clutch slave and engine mounts. the whole lot bolted up ok, 60 series 2f to '73 bellhousing, clutch and gearbox. It should all bolt up ok.
Old 40's last forever as long as you keep fixing the buggers...
'If ya didn't build it ya dont own it'
3rd Rock 4x4 member
'If ya didn't build it ya dont own it'
3rd Rock 4x4 member
Who is online
Users browsing this forum: No registered users and 0 guests