Outer Limits 4x4 Board

I just purchased a 60series 2F that is going into a 40 Series which has a 2F and 4spd.

A few questions

Is the input shaft on the 4spd the same size as the bush on the 60 series 2F?
Is the clutch the same as the 40 series? will i be able to bolt the bellhousing, clutch etc straight to the 40 series 4spd?

thanks.

your bellhousing will bolt to the new motor.
new bellhousing may not fit your g/box.

Fairly sure it all bolts up.

Last christmas I fitted a 2f out of a 60 series into a 1973 f 4 speed 40 series. the input shaft is the same, 10 spline, no problem. A 2f 4speed should be the same in a 60 or a 40.
My problem was, I didnt get the rear engine mounts and r/h clutch slave cylinder with the motor. So I had to swap over the origional f bellhousing with the l/h clutch slave and engine mounts. the whole lot bolted up ok, 60 series 2f to '73 bellhousing, clutch and gearbox. It should all bolt up ok.

Thanks for the help guys, hopefully i get it in within the next few weeks then.