Page 1 of 1

Mu Info, any help appreciated

Posted: Tue Jan 17, 2006 7:18 pm
by Cruzer!
The missus is pestering me aobut getting her a MU as her next car, and i've been looking at either the 2.8 or 3l diesels. Just a few Questions for your brains trust...

Whats sort of Reliabilty/Parts Issues are there? Are they mainly rodeo parts or are there a few Japan only bits 'n' peices?
(panels/etc.)

What sort of Towing Capacity do they have?

Any reoccuring Frequent problems to look out for when purchasing a MU, and what sort of price range (obviously extremely general) should i be looking at...

I'm not worried about blown engines/panle damage etc, I'm a mechanic and dont mind a project (i've got three others already :) )

Thanks,

Ben

Posted: Tue Jan 17, 2006 11:46 pm
by MissMU
parts in general are really hard to find or so ive found. if you do find them.. they are pretty expensive.

panels are NOT interchangeable between rodeos or fronteras unfortunately :( well maybe the grill/headlights...

main seal usually goes around the 140k mark... and alternators cost about $1000 to replace! timing belt goes at on or close to 100k

check out www.carsurvey.org there's bit of stuff on there. or check out clubisuzu.com quite a bit of stuff on there :D

when i was looking for one 2 weeks ago they were priced from 8k-13k depends on the condition!

PM sent ;)

Posted: Wed Jan 18, 2006 12:50 pm
by Pissy
Best place to look at and read from is the isuzu club.
Basically mechanicals and suspension are rodeo or Jackaroo pending on which engine you get (2.8 rodeo and 3.1 Jackaroo). Panels are a bit harder so I would try not to hurt them, if you do then you'll have to find a MU at the wreckers, this can be tough!

Usually people are unfamiliar with the MU as It is an import therefore they don't to try to fix them, say its too hard to fix or try to rip you off and source stuff overseas.

Just tell them its for a MU and ask for rodeo/Jackaroo parts and that will help ALOT.

Towing I am not too sure but its on the club site.

www.clubisuzu.com

There is heaps of support for parts and other questions for the MU on that web site. Trust me it has saved me $1000s by asking question in the forum for my MU.

Cheers

Posted: Wed Jan 18, 2006 5:09 pm
by Yarno
MissMU wrote:parts in general are really hard to find or so ive found. if you do find them.. they are pretty expensive.

panels are NOT interchangeable between rodeos or fronteras unfortunately :( well maybe the grill/headlights...

main seal usually goes around the 140k mark... and alternators cost about $1000 to replace! timing belt goes at on or close to 100k

check out www.carsurvey.org there's bit of stuff on there. or check out clubisuzu.com quite a bit of stuff on there :D

when i was looking for one 2 weeks ago they were priced from 8k-13k depends on the condition!

PM sent ;)
Panels are interchangable with rodeo and frontera, the front end is the same under the skin, the hardest thing to get is the guards (which are the same as the frontera except the blinker is in a different spot) because all the ricers have bought them for there mini trucks, so now holden have none and to get them at the wreckers is near impossiable.

Rear main seals will leak if the pvc valve blocks up.

Alternator is the same as rodeo, new they cost about $400, and can be repaired for about half that.

Timing belts are easy to get and not to hard to replace.


With towing you can fit the Jackaroo towbar, the MU weighs around 1800kg so towing would be very similar as the jack is about 1900kg.

As everyone has said info is at http://www.clubisuzu.com

Posted: Wed Jan 18, 2006 5:13 pm
by MissMU
i thought the alternator would be interchangeable... my mate is an auto elec and just finished doing one on a MU and his work charged the guy $1000! :?

Posted: Thu Jan 19, 2006 10:14 am
by Pissy
I got a 120amp alternator in my MU and that cost me $650 plus fitting?

Cheers
Chris

Posted: Tue Jan 24, 2006 4:25 pm
by bluemu
Perhaps best not to take your MU to your mates workplace missmu :D

Posted: Tue Jan 24, 2006 5:11 pm
by MissMU
lol yeh i wont be :lol: