Page 1 of 1
cams cages?
Posted: Sun Jan 22, 2006 7:33 pm
by Hoonz
say if you have a 4wd with a cams approved roll cage
and u want to take the cage out to put it into another 4wd
the only way is to cut the cage to get it out ... and re weld it in?
legal or not?
Posted: Sun Jan 22, 2006 8:29 pm
by krimnl
the pipe cannot be cut & rejoined , the hoop and the legs ect must be 1 peice without joins
Posted: Mon Jan 23, 2006 1:00 pm
by ludacris
You could turn it into a bolt in type of cage bu being carefull were you cut it. Not sure if cams approve bolt in though.
LudaCris
Posted: Mon Jan 23, 2006 1:01 pm
by Tiny
I do bolt as standard, CAMS approved, 6mm clamps
Posted: Mon Jan 23, 2006 1:53 pm
by Pinball
as i understand it you can do bolt in sections, but there has to be a specified length of solid bar before you return to tube in the barwork running into/out of the bolted join.
how bout you just cut and shut the cars?
Spock
Posted: Mon Jan 23, 2006 3:28 pm
by landy_man
yep... I would be pulling the roof off..... cage out... roof on...
But then I drive a Land Rover and it is a mechano set.. unsure what vehicle you have and if you have that option
Posted: Mon Jan 23, 2006 9:02 pm
by Hoonz
its all good the question has been answered
thanks all