Outer Limits 4x4 Board

Any idea's on a nice/neat way of protecting
the rear lower quater's.
Would prefer not to cut them off.

Cheers Ian.

but if you cut them off and put them in the cupboard they will be protected .

try build ya self a rear bar that protecks it

92mav wrote:but if you cut them off and put them in the cupboard they will be protected .

Cool idea, i'ii just put them next to the, rest of the stuff i dont whant damaged,dirty or missused .

You could in theory build a rear bar big enough..... imagine a rear bar about the size of the 100 series Cruiser..... then double it in width. Then double it again

Or run a normal steel bar, with some additional pipe like rocksliders running under the bottom of your quarters somehow attached so that when it takes a hit it doesnt move much.


Measuer how wide it needs to be - you'll find that there's at least a foot in height between the normal line a wrap around rear bar takes and the bottom of your quarter.



Most of the damage though normally comes from the end flaps of the weak GQ rear bar bending up... if you remove them and replace them with something more solid that comes around the side you may get away with that, a fair bit of lift and careful driving.