Page 1 of 1
BAR MODS FOR WINCH
Posted: Fri Mar 10, 2006 12:04 pm
by Loanrangie
Will 4mm plate be enough to brace my ARB bar for mounting a winch ?
I will be bracing in a c shape from mount along behind front of bar and then back to other mount.
Posted: Sat Mar 11, 2006 9:01 am
by Loanrangie
What, 80 views but no one has any ideas ?
Posted: Sat Mar 11, 2006 9:22 am
by ludacris
4mm is on verge but 6mm would be better. Brace and weld it though.
LudaCris
Posted: Sat Mar 11, 2006 9:43 am
by Ruffy
I would like to see at least 6mm as well.
It depends on what sort of bracing you are doing though.
Posted: Sat Mar 11, 2006 7:32 pm
by AFeral
My winch is mounted using 5mm has not bent or broken. There is a bit of bracing. Just make sure to run the bracing between the chassis mounting points and the winch and should be fine.