Outer Limits 4x4 Board

Silly question for you guys. The L28 is coming out tomorrow morning. Just got it all ready today. One thing I noticed - I couldn't see the lift point at the back of the engine! Where might it be? I don't really want to have to wrap something around the entire block. The front lift point also doesn't look too strong, but I hope it will be alright.

undo all the bolts, get the matress out again, flop your rig on its side and push it out, if it didnt hurt last time i cant see it hurting again

you could always find a bolt hole at the rear and put a bolt through the chain and lift off that,

Heathx4 wrote:Silly question for you guys. The L28 is coming out tomorrow morning. Just got it all ready today. One thing I noticed - I couldn't see the lift point at the back of the engine! Where might it be? I don't really want to have to wrap something around the entire block. The front lift point also doesn't look too strong, but I hope it will be alright.

got a arc?

or just start tearing into it and get down to the bare block...wrap some chains around and piss easy

could always just cut the front clip off and roll it out the side.

even better idea..you should have taken it out at mine and left it in my junkyard

did manda get the shit for lifting the crane in the cab?

Funny bastards. Used two seats belts with a reef knot to wrap around the back of the block. Did the trick. Was handy for the gearbox too.