Outer Limits 4x4 Board

hey guys

i picked up a second hand ARB locker fitted in a 40 series centre, which had a broken pinion. the carrier has a wide shallow gouge from the pinion about 20mm long, 10mm wide and 3mm deep. is this likely to majorly weaken the carrier, or should it be ok. Has anyone had an ARB carrier with this kind of damage and driven it hard with or without failure?

MILO

should be fine. pull it all apart and grind off anything higher than the original surface, clean it up and put it back together.

If you're real worried about it, you can buy the case as a spare part and it's reasonably priced.

I bought a second hand locker from Ruff a while back that had gouges right round it from when a pinion bearing collapsed and the pinion teeth touched the carrier.
The only problem I had was my fault. The steel air line touched on the carrier and the gouges rubbed through the line within about 15 mins. It would have only been a matter of time and a smooth carrier would have rubbed through too.
Other than that it has worked like a charm.
I would say the damage is superficial only.
Paul.

thanks guys

appreciate the help

Photo would help

Bazzle