Outer Limits 4x4 Board

Well as it suggests i just wanna make sure ive got em at the right ends and i guess if i put the pinions and crowns together they would prob only mesh between each equal pair considerin 1 set is reverse cut ...........But humour me anyway

Ive got the part no.s as follows off each

Crown front
M37:8 HM 8 11 14
Pinion front
37:8 DY 8 11 16
Crown rear
LS37:8 HM 8 11 12
Pinion rear
LS 37:8 DU 8 10 16



Now as i have them in these places allocated front to rear is this correct to the part no.s duzz anyone know..................

I only have em in this order due to the fact i thought it was prob obvious that the LS part no.s referred to limited slip???? hence why i put em together .........

And as mentioned in another topic these r from a GU 2.8 d and i know now that my RD09 locka aint gunna fit due to a chamfer on the inside of the crown being different and a rd78a is required (thanx Wendle)....Now the M37:8- HM 8 11 14 duzz have a larger (bigga) chamfer on the crown so i assume this is the front ........

ANY info or answers to the q's (thanx in advance )

ps my rd09 isnt gettin exchanged its gettin sold to WIZBIN from the board

Cheers DAN

get one of hypo's smashed 5.29 sets off him for comparison, as you know that they are standard rotation..