Page 1 of 1
TD42 Oil Pressure Sender
Posted: Fri May 05, 2006 8:09 pm
by MKPatrolGuy
OK, I have a new oil pressure sender to fit to the Mav (Thanks VRunner
). Just wondering if I need to put any Teflon tape or anything on the sender threads before I screw it in?
Cheers
Posted: Fri May 05, 2006 8:13 pm
by dirtyGQ
they are shite (gq pressure switch) instead of putting on thread tape you would be better off getting an aftermarket oil sender and gauge.
Posted: Fri May 05, 2006 8:16 pm
by MKPatrolGuy
dirtyGQ wrote:they are shite (gq pressure switch) instead of putting on thread tape you would be better off getting an aftermarket oil sender and gauge.
Thanks for the advice but I'm running the Standard gauge until I change dash pods and fit some new gauges.
So for the std sender do I need any form of thread sealant?
Posted: Fri May 05, 2006 10:24 pm
by jtraf
when I replaced mine I wound some teflon tape to be on the safe side......
Posted: Sat May 06, 2006 12:30 am
by MKPatrolGuy
jtraf wrote:when I replaced mine I wound some teflon tape to be on the safe side......
Cool, I will too then. Better safe than sorry.