Page 1 of 1
g16b engine angle question ????
Posted: Sun May 07, 2006 11:57 am
by 1Lzook
i am currently mounting my g16b into my sierra
what angle does the motor have to sit on ??
will the wrong angle affect the motor ?
Re: g16b engine angle question ????
Posted: Sun May 07, 2006 12:13 pm
by Damo
1Lzook wrote:i am currently mounting my g16b into my sierra
what angle does the motor have to sit on ??
will the wrong angle affect the motor ?
Straight up & down AFAIK. Shouldn't be a big drama if you need to tilt it a little for clearance though.
Posted: Sun May 07, 2006 12:33 pm
by 1Lzook
no like angle back
can it be tilted back
or does the inj rail have to sit flat ??
Posted: Sun May 07, 2006 8:00 pm
by Damo
1Lzook wrote:no like angle back
can it be tilted back
or does the inj rail have to sit flat ??
Can't recall exactly, but i'm pretty sure mine sits flat, or close to it. But I can't see why you couldn't tilt it back. The fuel rail is under pressure so tilting it a few degrees shouldn't bother it. I'm curious as to why you need to though?
Posted: Tue May 09, 2006 10:02 am
by Fity
If the engine didn't need oil it could run up side down.
So don't worry to much about the front to rear angles.
more important is the drive line angles.
Posted: Tue May 09, 2006 10:11 am
by christover1
Most of the stock vehicles I have seen usually have engine tilted back around 4-5*
But as said, the flanges on the drive line all need to be close to same as to avoid vibes.
My 1.3 sits back 4* and tilts to the passenger side a few.
Also motor doesn't sit directly in centre of the bay....
check out a few stock engines with a tape measure, and/or angl measure thing
christover
Posted: Tue May 09, 2006 7:57 pm
by 1Lzook
thanks for ure help guys
yeah the motor sits a little to the passanger side which is good because otherwise i would have issues with my brake master and my inlet manifold
thanks