Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
IDEAS...ANYONE?
Moderators: toaddog, TWISTY, V8Patrol, Moderators
IDEAS...ANYONE?
Hi all,I'm in need of a snorkle on my lux,but my problem is I have an exo,so 'safari' or the like is out of the question.Also my main problem is I don't want to obscure too much of the driver vision of the passenger side.Custom one seems to be the way to go,but anyones ideas would be TOPS

OVERKILL ENGINEERING
www.overkill4x4.com
(02) 94766137
www.overkill4x4.com
(02) 94766137
well i put a custom snorkle on my car, it wasnt nearly as hard as i thought it would be,it cost round $170ish
there are a few choises
-one piece steel
-custom plastic one with rubber elbow bends
PROs, and cons
-the one piece would be easier to keep water tight. harder to make/measure, looks good in stainless steel
-the plastic one is easier to make, quicker and is much cheaper, in some cases isnt as water tight
i made a plastic one.
http://www.4wdmonthly.com.au/forum/inde ... adid=16416
there are a few choises
-one piece steel
-custom plastic one with rubber elbow bends
PROs, and cons
-the one piece would be easier to keep water tight. harder to make/measure, looks good in stainless steel
-the plastic one is easier to make, quicker and is much cheaper, in some cases isnt as water tight
i made a plastic one.
http://www.4wdmonthly.com.au/forum/inde ... adid=16416
Real men smoke clutches
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
86' Pajero
2" OME, steel bar goodness, MTZ's, Exxon Valdez-esk fuel consumption
exactlyHotFourOk wrote:You could run it through the firewall into the dash...![]()
Have some mad induction noise in the cab
01 GU Patrol 4.2TD Wagon
God Of Emo
Posts: 7350
Joined: Sun Aug 24, 2003 7:04 pm
Joined: Sun Aug 24, 2003 7:04 pm
Location: Newy, home of the ZOOK (Rockin the 'diff)
Contact:
Hypolux (hypozook) had a flexible tube that ran under the cab and back behind the cab upwards. Might be woth a look, though then it is open to damage under the vehicle.
Layto....
Layto....
[quote="v840"]Just between me and you, I actually really dig the Megatwon, but if anyone asks, I'm going to shitcan it as much as possible! :D[/quote]
Who is online
Users browsing this forum: No registered users and 1 guest