Outer Limits 4x4 Board

hey was wondering if anyone had the front diff lower control arm bracket on diff bend where the control arm bolts too the diff cause my passenger side is all bent up and is too hard too straighten thinking of cutting them off and fabricating my own and welding back on anyone else done this

What control arms do you have?
The only time I;ve really seen this happen is when poor quality aftermarket arms are used.....And then I;ve seen brackets on the chassis damaged too.
So if you have poor quality arms, don't just renforce the lower brackets becuase chances are the uppers will be next.

its only the bracket on the diff thats bent just one side but cutting both off and fabricating new brackets too weld on i have the 4.5' superflex rubicon suspension so the arms are fine and im going too reinforce the top bracket too eventually

Yup superflex arms should be ok.
But when was the last time you greased them?
Remember if they get dry and seize up then all the twisting force goes to the brackets.

yep plenty of grease its all good now i fabricated some new diff brackets and will be welding them on tomorrow will be alot stronger cheers for the help