Hey guys,
I'm trying to install a Kaymar rear bumper on an HJ75 troopie. The bumper is supposed to bolt outside of the frame rails and to the rear crossmember as diagrammed here: <http://home.comcast.net/~dtay/kaymar.jpg>
Probably due to manufacturing tolerances, the side mounting tabs (coloured in green) are spaced about 3mm (1/8") narrower than the frame rails (B<A). I tried a large pry bar and a Hi-Lift jack to spread the tabs to no avail. Any suggestions? Anyone with a 70/73/75 had the same problems installing the Kaymar bumper?
I wanted to take a sledge hammer to the frame rails to narrow them but the neighbour next door had already gone to bed.
Dave
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Kaymar bumper on HJ75
Moderators: toaddog, Elmo, DUDELUX
Who is online
Users browsing this forum: No registered users and 1 guest