Outer Limits 4x4 Board

I saw a table once (might have been on here, but I searched and found nowt) that showed how many metres of rope you could fit.

But I can't find the damn thing anymore.

Does anyone know how much rope fits onto a Warn XD9000? I'm thinking 10mm.

Going to replace the cable on the Aldi Chinese Warn knock off too. They reckon its 9,500lb.......

http://www.rockstomper.com/catalog/recovery/ropes.htm

Warn XD9/XD9i 5/16x125 3/8x100

I was looking for some plasma rope for my high mount and stumbled on the dynamica rope web site it's got a table on there that gives you nearly every type winch cable specs, lengths and so forth hope this helps

Hally wrote:I was looking for some plasma rope for my high mount and stumbled on the dynamica rope web site it's got a table on there that gives you nearly every type winch cable specs, lengths and so forth hope this helps

this is the link
http://www.secondair.com/pix/pdf/dynami ... pedata.pdf

Don't be tempted to squeeze to much on, especially on a low mount. I t just means the you need to be more careful with the set up and keep an eye on it more. It's a real pain in the ass once it has bunched up and jammed itself between the tie bars.

JF

I have 125' on mine without any problems. How much did you want to put on it?

Thanks fellas, that's exactly what I was looking for. It was the Rockstomper site I needed.

I was just gonna put125' (38-40m) on them both.

You are not alone, chasing plasma rope etc. I have a Warn 9000, and looking to replace the wire with plasma. I'd appreciate knowing where you end up getting the cable from.
Thanks.