Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

winch wont go?

For all things Electrical.

Moderator: -Scott-

Forum rules
Post Reply
Posts: 28
Joined: Wed Jun 30, 2004 4:34 pm
Location: long way south/////////

winch wont go?

Post by sunny jim »

just swapped warn 9000lb winch from landcruiser with arb bar, to a gu ute with a nissan bar, had to rotate motor end 90 degree, did that, so it would fit. wired every thing up , plugged control in, nothing!!! what should i work through to eliminate the problem, could it be the ground wire? have i connected it up wrong inside control box? any ideas... :roll:
LC 100, GU ute.
Top
Posts: 1232
Joined: Sun Feb 29, 2004 11:37 pm
Location: Brisvagas

Post by Bad JuJu »

Did you put the -ve back on. Its a bolt on the other side of the motor to the three studs that connect to the control box?
Posting quality not quantity!

Wanted: Stock HiLux Front Leaf Springs
Top
Posts: 28
Joined: Wed Jun 30, 2004 4:34 pm
Location: long way south/////////

Post by sunny jim »

Bad JuJu wrote:Did you put the -ve back on. Its a bolt on the other side of the motor to the three studs that connect to the control box?
can you explain that a little more!!!!!!! :?
LC 100, GU ute.
Top
Posts: 1232
Joined: Sun Feb 29, 2004 11:37 pm
Location: Brisvagas

Post by Bad JuJu »

Did you connect the negative (black wire) to the winch body, It dosen't earth with out it.
Posting quality not quantity!

Wanted: Stock HiLux Front Leaf Springs
Top
Post Reply

Return to “Auto Electrical”

Who is online

Users browsing this forum: No registered users and 0 guests