Outer Limits 4x4 Board

just swapped warn 9000lb winch from landcruiser with arb bar, to a gu ute with a nissan bar, had to rotate motor end 90 degree, did that, so it would fit. wired every thing up , plugged control in, nothing!!! what should i work through to eliminate the problem, could it be the ground wire? have i connected it up wrong inside control box? any ideas...

Did you put the -ve back on. Its a bolt on the other side of the motor to the three studs that connect to the control box?

Bad JuJu wrote:Did you put the -ve back on. Its a bolt on the other side of the motor to the three studs that connect to the control box?

can you explain that a little more!!!!!!!

Did you connect the negative (black wire) to the winch body, It dosen't earth with out it.