Page 1 of 1
transfer diffrence
Posted: Sun Oct 08, 2006 7:24 pm
by ronoor
is there any way you can tell the diffrence between 1.3 and a 1 L transfer case as a mate has 1 in his shed. not quite sure on what it is. cheers ron
Posted: Sun Oct 08, 2006 7:40 pm
by PJ.zook
The main difference i think is the 1litre transfers dont have an electrical switch to turn on the dash light to say if its in 4wd or not.
Posted: Sun Oct 08, 2006 7:46 pm
by Oscars
mine did i think, the amount of turns it takes from the input and output flanges i think
Posted: Sun Oct 08, 2006 7:49 pm
by Rhett
12% lower in both high and low range
Posted: Sun Oct 08, 2006 9:13 pm
by christover1
Unless its been modded, a 1 litre t-case has smaller flanges and different stud pattern on the yokes.
early ones had no 4wd light, but later ones did.
christover
Posted: Sun Oct 08, 2006 9:24 pm
by ronoor
cheers thanks for the info
Posted: Mon Oct 09, 2006 12:11 pm
by tazzazuk
wat is involved in adpating the 1.3 flange to the 1 transfer
Posted: Mon Oct 09, 2006 1:38 pm
by christover1
tazzazuk wrote:wat is involved in adpating the 1.3 flange to the 1 transfer
If its a 4wd light 1.0 litre case, then the flanges swap over from the 1.3 narrow track case, but nuts need a lot of power to undo......I am not sure of the 1.3 widetracks.
christover