Page 1 of 1
VS ECOTEC V6 INTO 4RUNNER
Posted: Sat Dec 16, 2006 2:35 pm
by drduff
I AM PUTTING A VS ECOTEC V6 INTO MY 94' RV6 4RUNNER. ANYBODY HAVE ANY INFO,STORIES OR PROBLEMS TO LOOK FOR WHEN I DO THIS CONVERSION?
ALSO, WHERE IS THE BEST PLACE TO GET THE CONVERSION KITS FROM?
Posted: Sat Dec 16, 2006 5:59 pm
by zookdave
theres a place called marks adapters . they sell all adapters for alot of cars for lots of conversions so browse their website
http://www.marks4wd.com/
Posted: Sun Dec 17, 2006 4:04 pm
by toyrex
Is your 4runner manual or auto
Marks for the conversion kit
www.marks4wd.com
Chevtorque for a one piece nodular iron flywheel and 11 blade viscous fan
www.chevtorque.com.au
Adrian
V6 CONVERSION
Posted: Sun Dec 17, 2006 4:30 pm
by drduff
I will be using the original manual gearbox.
Anybody else done this conversion?
Posted: Sun Dec 24, 2006 8:39 pm
by toyrex
Posted: Mon Jan 01, 2007 4:25 pm
by Beefcake
I've done a VN V6 into an 84 dual cab. Am about to do it again with an '85 Runner. Not sure which engine I will go with but. Will try for an Ecotech I think. One thing I know for sure is I will be using the holden auto this time. I did 3 std toyota boxes in three months. I admit I gave it a hiding back then. Another thing is be sure to use some kind of a surge tank for the fuel system. I did not have this last time and it would starve for fuel under acceleration and up hills etc. The Marks4wd website others have mentioned above has plenty of info and everything is well listed.
Good Luck with it...