Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
how many degress to tweek the diffs for a 5" lift
Moderators: toaddog, Elmo, DUDELUX
Posts: 3523
Joined: Sun May 18, 2003 8:42 pm
Joined: Sun May 18, 2003 8:42 pm
Location: Somewhere they can't reach me, shoot me or electrocute me...
You'll have to get out the angle finder to determine the angles for caster in the front, and pinion flange in the rear. you can use a protractor combination square with a spirit level to determine the angles. Match the rear drive flanges (diff and transfer) to run parallel, you can do this by loosening the u bolts, titling the pinion up or down and measuring the gap between the spring perch and the spring. Then just get the caster wedges to suit. do the same with the front, only dial in enough caster (check the manual) so it will track well. Caster wedges are pretty easy to make (provided you are good with tools) after not finding any affordable locally, I shaped them with out of some 12x60 flat aluminium bar, a 6 inch power saw, triple cut blade, electric planer and some Mr Sheen for lube to stop the alum galling.
Built, not bought.
Who is online
Users browsing this forum: No registered users and 64 guests