Outer Limits 4x4 Board

Sorry for this, should have included it in my other post, how much of the guard do i cut off to fit 33's with only a 2" body lift.
Thanks for your patience

Dixie

Dixie,

When I cut for my Q78s (narrow 35.5") I just cut up to within about 10mm of the line of the natural 'flare' on the guards, then folded each of the tabs under.

You may have to cut more, depending on the width of your tyres, but any less and it wouldn't look as good.

Thanks Andrew,

I finally did it and all i did was basically followed the contour of the flare cutting just above, it doesn't look to bad, now I have to some fit flares as I didn't leave any tabs. Now to put the MTRs under and check for clearance might have to get some new springs because I think she is sagging.

Dixie