Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

How much to cut

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 137
Joined: Mon Nov 17, 2003 1:33 pm
Location: Hornsby Heights

How much to cut

Post by MQ SWB »

Sorry for this, should have included it in my other post, how much of the guard do i cut off to fit 33's with only a 2" body lift.
Thanks for your patience

Dixie
There is no such thing as a stupid question only stupid people
Top
Posts: 876
Joined: Wed Apr 14, 2004 7:30 pm
Location: Terrigal, NSW

Post by fightara »

Dixie,

When I cut for my Q78s (narrow 35.5") I just cut up to within about 10mm of the line of the natural 'flare' on the guards, then folded each of the tabs under.

You may have to cut more, depending on the width of your tyres, but any less and it wouldn't look as good.
Top
Posts: 137
Joined: Mon Nov 17, 2003 1:33 pm
Location: Hornsby Heights

Post by MQ SWB »

Thanks Andrew,

I finally did it and all i did was basically followed the contour of the flare cutting just above, it doesn't look to bad, now I have to some fit flares as I didn't leave any tabs. Now to put the MTRs under and check for clearance might have to get some new springs because I think she is sagging.

Dixie
There is no such thing as a stupid question only stupid people
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 23 guests