mounting an internal cage

[410sierra]

Hi i've changed my mind after all. i am getting an internal cage

i was just wondering if it were possible to get a couple of pics of how

people have mounted thiers. As i am not sure where the best spot would be.

Thanks Brad

[Pinball]

pics on Pointnshoot4wd.org

or depending where u are, can probably get a direct eyeball for you.

Spock

[Klappers]

through the front dash and then have a hoop going over the back of the seats and under the "roll" bar. and then cross brace

[410sierra]

Pinball: Thanks for the pics. Iwas able to get hold of an old mate so i was albe to check his cage out. thanks for the offer tho

Klappers: i was pretty sure thats how it was done but just wanted to check.

brad

[patzuki]

How much does a cage cost? Is it cheaper to go an exo?

[410sierra]

im looking at paying about a grand for a fully comp spec
internal rollcage.

I was told it would be more expensive for an external. Tho dont now
how much.

[Klappers]

internal would look the goods and protect you...which is a good thing i think..doesnt seem to be much protection in a soft top

[oozuk]

if your chasing info on roll cages for sierra's then check out my build thread as i've recientily done a internal 4 point roll cage with intrusion bars included in the roof and above the dashboard, i used 350 CDW Racetech roll cage matearial, air over hyd speedworx pipe bender and all welds were mig welded.

has all ready sustained a roll over at 40 km\hr mucking around, had no roof, windscreen, doors or back on only rollcage, seats and racing harnsess, cage is sooooo strong only scratched the paint off it didn't even dent it or bend it, i now competily trust this cage with my life for if and when my suzuki comes off second best