Outer Limits 4x4 Board

I have just about figured out how to rebuild my weber, but I would like to know how to set the float level to 41mm as stated in a few weber topics. I want to prevent the incline problem that weber tend to suffer.
cheers

Hi Jaczook have a good read through the webber thread on this site, also check www.offroad.com posts by sarge. I tried to post some pics but it didnt work. If its an old carb I highly recomend buying a rebuild kit to do at the same time. Its not very hard and if your setting the float you should put a kit in it. It will also give you detailed instructions on how to do it. P.S brass and plastic floats have different settings. Good luck.
Nik