Page 1 of 1
Removing pully from vn v8 p\s pump
Posted: Fri Dec 29, 2006 1:04 pm
by tuf045
Does any one know if it is possible to remove the pully from a vn v8 power steering pump? If so is the allen headed bolt left or right hand thread?
Posted: Fri Dec 29, 2006 1:06 pm
by CRUSHU
AFAIK the pulley is pressed on, the allen key hole is so you can hold or turn the shaft.
You need a power steering pump puller/fitter. If you don't use one, you will almost definately root the pulley, either removing it or refitting it.
Posted: Fri Dec 29, 2006 1:23 pm
by tuf045
CRUSHU wrote:AFAIK the pulley is pressed on, the allen key hole is so you can hold or turn the shaft.
You need a power steering pump puller/fitter. If you don't use one, you will almost definately root the pulley, either removing it or refitting it.
Where would i get one of these are they Genuine holden parts.
Posted: Fri Dec 29, 2006 4:51 pm
by Ruggers
most places like bursons, repco and bearing supply joints sell a kit for p/s pully it slides over and hooks on the rib the screws in pressing the pully of then the kit should have a installed which screws into the thread on the shaft and press's it back on there not to expensive and handy to to have as they do alts and water pump pulleys for a range of different vehicles
Posted: Fri Dec 29, 2006 6:24 pm
by cloughy
What they said, they're also not a holden pump, they're made by saginaw, and fords been using them forever aswell
Well since XD falcons anyway
OOPS
: Typo
Posted: Fri Dec 29, 2006 11:47 pm
by CRUSHU
cloughy wrote:What they said, they're also not a holden pump, they're made by sadinaw, and fords been using them forever aswell
Well since XD falcons anyway
Ahh, that would be Saginaw..... an OEM supplier.