Outer Limits 4x4 Board

Ok I have stuffed the rear uni joints and i need to replaec them. Whats involved? Is it easy? or is it just easier to pay someone?

Do you have a good mechanical aptitude?????
They are not hard to do if you have a little nouse. Remvove the tail shaft. Remove the circlips from the uni joint caps, on the inside of the yoke.
Support the shaft on an open vice. Have the jaws open about 3/4 of the diameter of the shaft. Support the shaft on the welded section NOT the tubular section of the shaft, it will dent!!!
Hit the loose yoke downwards to push the lower cap out of the shaft. Repeat on other side.
If you have any doubts and want to save a little then remove the shaft yourself and take it to a w/shop to fit uni's

Cheers, Dan

Ok sounds easy cheers

Just make sure when replacing a roller doesnt fall out of place.

Bazzle