Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Series 3 Wagon Body Chop

Tech Talk for Rover owners.

Moderator: Micka

Forum rules
Post Reply
Posts: 66
Joined: Sat Nov 20, 2004 12:27 am
Location: Perth

Contact:
Contact Chrismb

Series 3 Wagon Body Chop

Post by Chrismb »

has anyone Chopped a series 3 wagon body to a tray top? I've seen them chopped at the back to make a dual cab, but not at the front.

it would be nice to get it to something like this one http://www.outerlimits4x4.com/viewtopic ... ht=#634392 but I think that was a ute body to start with.
Top
Posts: 231
Joined: Mon Dec 20, 2004 9:43 am
Location: lost in my pile of parts

Post by Tim D »

why not just install a ute cab rear lower section,should bolt up.may need to move the 4 mounts on the chassis(easy job),i think they're around 40mm too far back or forward.been a while since i done one,as for the roof you could chop yours and make it fit the ute cab lower.
Top
Post Reply

Return to “Rover”

Who is online

Users browsing this forum: No registered users and 5 guests