Outer Limits 4x4 Board

has anyone Chopped a series 3 wagon body to a tray top? I've seen them chopped at the back to make a dual cab, but not at the front.

it would be nice to get it to something like this one http://www.outerlimits4x4.com/viewtopic ... ht=#634392 but I think that was a ute body to start with.

why not just install a ute cab rear lower section,should bolt up.may need to move the 4 mounts on the chassis(easy job),i think they're around 40mm too far back or forward.been a while since i done one,as for the roof you could chop yours and make it fit the ute cab lower.