Page 1 of 1
cruiser crawler box
Posted: Mon Jan 29, 2007 7:57 pm
by 75 cruser
cruiser crawler box
have been looking at running one of these for a while and was looking for any disadvantages and advantages to running one of these any problems with installation etc
rob
Posted: Mon Jan 29, 2007 8:11 pm
by MissDrew
PM MUD000, he has just had one installed in his 79 series.
box
Posted: Mon Jan 29, 2007 9:17 pm
by 75 cruser
have been talking to mud 000 just looking for other experances
rob
Posted: Mon Jan 29, 2007 9:40 pm
by DIRTY ROCK STAR
cost seems to be the biggest drama.
where were you looking at getting it thru?
Posted: Tue Jan 30, 2007 11:13 am
by dow50r
They are too large to fit in there without a 2 inch body lift, and with an 80 series, a cut down main tank.you cant use them with a PTO, you need compressed air to run them and its more than just a straight bolt on, bearings need to be shimmed to correct tolerances etc...having said all that, you have 3 low range ratios to choose from, std 2.5, lower 3.05 and lowest 7.5 reduction. Good for any terrain, and tyre size, and no loss of high range gearing.
Posted: Tue Jan 30, 2007 1:14 pm
by DIRTY ROCK STAR
7.5:1
not bad.
but it certainly sounds like alot of work to fit.
Posted: Tue Jan 30, 2007 4:28 pm
by MUD000
would not of hadto have a bodylift to fit mine heaps of room
Could of used the main tank but got hole new one made up as the rear one was pretty exposed now with no springs to protect
Was a fair bit of work to fit $$$$$$
But hopefully well worth it
Mine goes back to Cheezy this weekend to get finished
Looking at doing the night pursuit this year as I got asked today to go in it
So this may be its first real work out
Cheers Dan