Page 1 of 1

Uni Joint Grease

Posted: Sat Feb 10, 2007 9:00 am
by oondy
WHat grease should I use for the uni's on the front & rear drive shafts - and the slip joints aswell?

I used some Mobil XHP222 grease (coz it was in the gun) but I was under the bus the other day after i had come back from a short drive and the grease had melted and formed a slight drop on the end of the slip joint seal.

Do i need a higher melting point grease? or is XHP222 just crap

cheers

OONDY

Posted: Sat Feb 10, 2007 10:19 am
by Hoonz
u need high temp grease .... bearing grease or the likes of that

Posted: Sun Feb 11, 2007 5:45 pm
by weeksy
High Temp & Extreme Pressure :lol:

Posted: Mon Feb 12, 2007 2:58 pm
by lolergram
weeksy wrote:High Temp & Extreme Pressure :lol:
The word 'Extreme' is over-rated :finger:

Posted: Mon Feb 12, 2007 3:02 pm
by weeksy
lolergram wrote:
weeksy wrote:High Temp & Extreme Pressure :lol:
The word 'Extreme' is over-rated :finger:
Yes I agree...

As some peoples idea of "Extreme Off Roading" is rather lame.

Posted: Mon Feb 12, 2007 5:52 pm
by rover1
i use castrol LLM in uni's and cv's.