Outer Limits 4x4 Board

The ball joint spacers are 1 inch and diff spacers to reduce the angle of the cvs .The exhaust runs under the drivers side (petrol ) until past the transfer case.

the piece above the bash plate is stainless plate with holes in , after the body lift there was a big hole . There to stop stuff going up into the radiator.

After just finishing a balljoint spacer and diff lowering mod I was unable to fit the front drive shaft to the front diff due to the exhaust . I have had the exhaust re routed to travel further along the rhs of the vehicle along side of the transfer case and up and over the rear tailshaft. Would the ...

Just finished making up a new bash plate from checkerplate for my hilux, Does it require holes for ventilation to the engine and gearbox?

98 hilux extracab with tonneau and no hooks.Was already done to vehicle before i got it.

The front diff is without the add and the spare is the same so this should be ok to get the locker fitted and swap staight over. I think that the info on the rear , lsd being stronger , was refering to the cast housing being bigger on the later model ifs hilux so putting the locker in the older type ...

I am after some info on the diffs for my 98 model 2.7 ifs hilux. I am now running 33's and am looking to fit air lockers and change the diff ratios from 4.3 to 4.8 . I bought a spare set of diffs for the front and rear with 4.8 in them but have found out that the ifs model has a wider axle in the ...