Ok guys i have a problem
I have just installed a new engine in my 1990 suzuki sierra. It is the exact same 1.3L engine as what was originally in it except its been rebuilt. The installation went smoothly however the car will not start and idle it turns over alright but wont fire up. When i put my foot flat on the accellerator and try to start it it shoots flames out of the top of the carby. Apparently the ignition timeing has to be set but i can't figure out how to do it. Can anyone help me if so it would be much appreciated.
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Engine installation problems
Yep think Davo is on the money here. I had the same problem after changing leads. Wouldnt fire checked everything had a beer, rechecked and another beer etc. Turned out when I built the motor 3years ago I put the dizzy in 180o out but somehow fluked the plug leads wrong aswell so it ran. When I changed the leads I got the leads right which was wrong compared to the dizzy.
Nik
Nik
Who is online
Users browsing this forum: No registered users and 0 guests