Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

rebuilding gearbox

Tech Talk for Suzuki owners.

Moderators: lay80n, sierrajim

Post Reply
Posts: 4
Joined: Sun Feb 25, 2007 9:18 pm

rebuilding gearbox

Post by joeyree »

We have to replace bearing in 1982 suzuki sierra gearbox as it gets stuck in 4th gear. does anyone know where we can get rebuild instructions on the internet. Hubby is going to have a go while we're on holidays. Has anyone done it before, is it hard. Thanks
Posts: 287
Joined: Wed Feb 15, 2006 7:00 pm
Location: Perth, WA

Post by smiley_smoke »

http://www.suzukiinfo.com/sierra/trannyrebuild.zip

i just rebuilt mine with the help of my mate. its not overly hard but if he hasnt done it before i dare say he should ask for help before rather than later.. easier and cheaper that way.
the input shaft bearing will probably be the most worn, and since you are cracking the box to get at any of the bearings you may as well put a kit through it and look at putting in a new shifter bush and shifter locator bolt.. these are cheap and tend to wear over time.
oh and good luck! :D
2" Susp lift, Ext shackles, RTC damper; Offsets, Custom interior panels, Stereo (+Sub), rubber Checkerplate floor, Custom Centre console, Under bonnet storage
Soon: Aircon + tinting?
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests