Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
80 Series speedo correction
Moderators: toaddog, Elmo, DUDELUX
80 Series speedo correction
Yes, I searched.
My brother has a diesel 80 series, which he actually uses offroad (Cape York, Kimberly, Simpson, Anne Beadell...) But he's still running 31x10.5R15 Bridgestone Desert Duellers, and gets punctures where the rest of us (various 16" sizes) don't.
He's happy to buy 16s (money is not an issue) but he wants his speedo to be accurate - so he's not keen to go 265/75-16 (nominally a 32").
He reckons he's currently within 1% at 100km/h, and doesn't want to lose that. So he doesn't care that 32s would only be about a 3% change - it's too much.
I know there are electonic adjusters available, but I wouldn't be happy with that myself, so I'll have trouble selling the idea to him. I've seen some mention of replaceable gears to correct the speedo, but not sure how big a job this is.
Can anybody supply some part nos, and/or rough idea of how hard to replace?
Thanks,
Scott
My brother has a diesel 80 series, which he actually uses offroad (Cape York, Kimberly, Simpson, Anne Beadell...) But he's still running 31x10.5R15 Bridgestone Desert Duellers, and gets punctures where the rest of us (various 16" sizes) don't.
He's happy to buy 16s (money is not an issue) but he wants his speedo to be accurate - so he's not keen to go 265/75-16 (nominally a 32").
He reckons he's currently within 1% at 100km/h, and doesn't want to lose that. So he doesn't care that 32s would only be about a 3% change - it's too much.
I know there are electonic adjusters available, but I wouldn't be happy with that myself, so I'll have trouble selling the idea to him. I've seen some mention of replaceable gears to correct the speedo, but not sure how big a job this is.
Can anybody supply some part nos, and/or rough idea of how hard to replace?
Thanks,
Scott
Scott
if he gets a petrol spedo face and places it over the diesel spedo, he will get a 10% speed up and can then run 35's. Another great idea is to put the gear out of a later 80 in the transfer, it has one more tooth, and spins slower as a result. Temember, pre 8/92 had cable and cant be corrected electronically
Andrew
if he gets a petrol spedo face and places it over the diesel spedo, he will get a 10% speed up and can then run 35's. Another great idea is to put the gear out of a later 80 in the transfer, it has one more tooth, and spins slower as a result. Temember, pre 8/92 had cable and cant be corrected electronically
Andrew
How different is the cable speedo drive on the early 80 series to the 60 series? did all the early 80 series come with 15 inch wheels, were the 16 inch rims an option on the early models? If they were an option, was there a difference in drive gears??
(wondering if speedo correction can be done for a 60 series using 80 series drive bits....)
(wondering if speedo correction can be done for a 60 series using 80 series drive bits....)
No mines a Petrol and because its a late model it came factory with 16" rims. The Prado rims should bolt straight on. Offsets may be different and just make sure they clear the caliper before driving it.-Scott- wrote:Thanks Tony - is yours a diesel too?RUFF wrote:Ive got 265/75/16s on my 96 and the speedo is spot on. It runs axactly the same as my Garmin Streetpilot's speedo.
Dad's got 265/75-16 on his Prado - factory steel rims. Will they bolt onto the 'Cruiser to take it for a test run?
Prado bolt straight on, they are 1 inch less wide, but thesame backspace as the 80 rim...-Scott- wrote:Thanks Tony - is yours a diesel too?RUFF wrote:Ive got 265/75/16s on my 96 and the speedo is spot on. It runs axactly the same as my Garmin Streetpilot's speedo.
Dad's got 265/75-16 on his Prado - factory steel rims. Will they bolt onto the 'Cruiser to take it for a test run?
One more thing, the prado had 265x70 std (not 75) these are smaller than the 75...the 265x75 is equivalemt to the 275x70 std cruiser grandtrek-Scott- wrote:Thanks Tony - is yours a diesel too?RUFF wrote:Ive got 265/75/16s on my 96 and the speedo is spot on. It runs axactly the same as my Garmin Streetpilot's speedo.
Dad's got 265/75-16 on his Prado - factory steel rims. Will they bolt onto the 'Cruiser to take it for a test run?
OK - perhaps you know something I don't.dow50r wrote:One more thing, the prado had 265x70 std (not 75) these are smaller than the 75...the 265x75 is equivalemt to the 275x70 std cruiser grandtrek-Scott- wrote:Thanks Tony - is yours a diesel too?RUFF wrote:Ive got 265/75/16s on my 96 and the speedo is spot on. It runs axactly the same as my Garmin Streetpilot's speedo.
Dad's got 265/75-16 on his Prado - factory steel rims. Will they bolt onto the 'Cruiser to take it for a test run?
The man who claims to be OUR father has 265/75-16 on HIS Prado.
Check this out,
http://www.marks4wd.com/products/tyre_m ... ction.html
I have one of these fitted, just with a flick of teh switch, once you've taken 10 minutes to set it up and you can flick the speedo to read correctly between your 31 inch highway tyres and the 38 inch play tyres. AND works for all tyres sizes. I can not distinguish any difference between the speedo and GPS, wiht differing tyres sizes, just flick to another program in the "little box".
Juz
http://www.marks4wd.com/products/tyre_m ... ction.html
I have one of these fitted, just with a flick of teh switch, once you've taken 10 minutes to set it up and you can flick the speedo to read correctly between your 31 inch highway tyres and the 38 inch play tyres. AND works for all tyres sizes. I can not distinguish any difference between the speedo and GPS, wiht differing tyres sizes, just flick to another program in the "little box".
Juz
You can change the speedo driven gear in the transfer case.
That was the only change they did from 15in to 16in rims.
you can buy it from toyota, it comes with a new seal aswell.
Its easy to do, just pull out the speedo drive out of the transfer case, pop of the cir clip, push the speedo drive shaft out , replace the seal and replace it with the 16 inch version, refit cir clip refit to car.
Under 30 mins all done, hardest part replacing the seal
That was the only change they did from 15in to 16in rims.
you can buy it from toyota, it comes with a new seal aswell.
Its easy to do, just pull out the speedo drive out of the transfer case, pop of the cir clip, push the speedo drive shaft out , replace the seal and replace it with the 16 inch version, refit cir clip refit to car.
Under 30 mins all done, hardest part replacing the seal
Well I've just finished installing the Jaycar unit on my 80. For anyone thats interested I've made write up on the install, have a look at this link http://www.offroad80s.com/viewtopic.php?t=482
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
Last edited by shanegtr on Thu Aug 09, 2007 4:51 pm, edited 1 time in total.
80 Series forum
www.offroad80s.com
www.offroad80s.com
Im here for the sausage!
Probably not.. go under tree cover, into a tunnel, even in a 'canyoned' urban environment you could drop all your sats and suddenly have no speedo.DIRTY ROCK STAR wrote:As abit of an add onto this, is a mounted GPS legal as a speedo??
if you were to run 35s in an fj40 and needed it engineered what speedo options are there?
with dual GQ transfers and a TH400 with 80 diffs?
any ideas??
GPS itself is extremely accurate, probably better than your average radar gun, but can drop out to easily to be relied apon.
Id be searching for a speedo company, there is a place near me in ringwood, but that doesnt help you out, let your fingers do the walking prob
Cheers,
Dan.
[i]1996 HDJ80R[/i]
Dan.
[i]1996 HDJ80R[/i]
Shanegtr,shanegtr wrote:Well I've just finished installing the Jaycar unit on my 80. For anyone thats interested I've made write up on the install, have a look at this link http://http://www.offroad80s.com/viewtopic.php?t=482
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
The link doesn't seem to work - maybe requires password? Any chance of sending me a PM of the write up or posting it up here?
Cheers.
Nevermind. http://www.offroad80s.com/viewtopic.php?t=482Dak Dak wrote:Shanegtr,shanegtr wrote:Well I've just finished installing the Jaycar unit on my 80. For anyone thats interested I've made write up on the install, have a look at this link http://http://www.offroad80s.com/viewtopic.php?t=482
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
The link doesn't seem to work - maybe requires password? Any chance of sending me a PM of the write up or posting it up here?
Cheers.
Im here for the sausage!
+dj_hansen+ wrote:Probably not.. go under tree cover, into a tunnel, even in a 'canyoned' urban environment you could drop all your sats and suddenly have no speedo.DIRTY ROCK STAR wrote:As abit of an add onto this, is a mounted GPS legal as a speedo??
if you were to run 35s in an fj40 and needed it engineered what speedo options are there?
with dual GQ transfers and a TH400 with 80 diffs?
any ideas??
GPS itself is extremely accurate, probably better than your average radar gun, but can drop out to easily to be relied apon.
Id be searching for a speedo company, there is a place near me in ringwood, but that doesnt help you out, let your fingers do the walking prob
yellow pages it is!
EVERYONE LOVES A 40
www.lovells.com.au
RAW4x4
www.lovells.com.au
RAW4x4
Fixed my original link - dont know how I managed a double http?Dak Dak wrote:Dak Dak wrote:Shanegtr,shanegtr wrote:Well I've just finished installing the Jaycar unit on my 80. For anyone thats interested I've made write up on the install, have a look at this link http://http://www.offroad80s.com/viewtopic.php?t=482
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
The link doesn't seem to work - maybe requires password? Any chance of sending me a PM of the write up or posting it up here?
Cheers.
Nevermind. http://www.offroad80s.com/viewtopic.php?t=482
80 Series forum
www.offroad80s.com
www.offroad80s.com
Yeah I should have noticed that!shanegtr wrote:Fixed my original link - dont know how I managed a double http?Dak Dak wrote:Dak Dak wrote:Shanegtr,shanegtr wrote:Well I've just finished installing the Jaycar unit on my 80. For anyone thats interested I've made write up on the install, have a look at this link http://http://www.offroad80s.com/viewtopic.php?t=482
It works a treat and can be set within 1% up to 99%(thats some big arse tyres )
The link doesn't seem to work - maybe requires password? Any chance of sending me a PM of the write up or posting it up here?
Cheers.
Nevermind. http://www.offroad80s.com/viewtopic.php?t=482
The kit sounds pretty good. I'll check it out. It's satisfying making it yourself too. I purchased and made one of their dual battery management systems which I'm not sure that they still make. Works well though also.
Who is online
Users browsing this forum: No registered users and 3 guests