Notice: We request that you don't just set up a new account at this time if you are a previous user. If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Well my $200 stockman that is really gonna be used as paddock vehicle,definataly not registerable,already has spring over on the rear and the front is yet to be done.I was gonna pull out whole diff/axle housing and remove the plate attached to bottom of the housing and re attach to the top and maybe brace it too.
It wont be a race or rock climber but i thought a bit more clearance and articulation would help.
Any fors or against this idea.
Most likley quicker to get a piece of 4x2 box steel about 4mm sidewall and get busy with the hole saw (WD40 can is about same diameter as zuk diff)
Once you cut the hole cut the box in half with your trusty gringer .. 2 spring saddles ..
" If governments are involved in the covering up the knowledge of aliens, Then they are doing a much better job of it than they do of everything else "
Not real sure how to load photos but some one at work here will give me a hand.seems easy to make new perches but with the hot axe im pretty accurate.Ill try to get some shots loade when i can.
Well my $200 stockman that is really gonna be used as paddock vehicle,definataly not registerable,already has spring over on the rear and the front is yet to be done.I was gonna pull out whole diff/axle housing and remove the plate attached to bottom of the housing and re attach to the top and maybe brace it too.
Not real sure how to load photos but some one at work here will give me a hand.seems easy to make new perches but with the hot axe im pretty accurate.Ill try to get some shots loade when i can.