I went out fishing on Sat , pulled up on the beach to set up and could smell this horrible burning smell... so much the kids thought there was a fire somewhere near by .
I searched all the wiring as the smell is an electrical / plastic smell .
Drove home and yup it is still there .
I can smell it strong when the bonnet is closed up along the gap between bonnet and fender on the drivers side .
I can touch every wire and cant find any hot to the touch , battery is not hot nor the terminals .
I disconnected the duel batteries solenoid and the smell is still there .
I had a mate come over and he can smell it bad , but still neither of us can actually locate or identify the problem .
All fuses work , no sign of burnt or smoke , so I'm asking for ideas please .
What should i be looking at /for
Thanx in advance
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
Range Rover 300tdi electrical burn smell
Moderator: Micka
no breather lines/looms etc hanging on the exhaust?
Had a smoke leakage in my rangie a few years ago, before I bought it off the folks, and couldn't find the source - ended up continuing driving and watching the vents, but nothing. Nothing showed up looking for it, and eventually about 6 months later ended up discovering (while looking at something completely unrelated) that the floor mounted dip switch for high beam someone had fitted had zapped itself.
Had a smoke leakage in my rangie a few years ago, before I bought it off the folks, and couldn't find the source - ended up continuing driving and watching the vents, but nothing. Nothing showed up looking for it, and eventually about 6 months later ended up discovering (while looking at something completely unrelated) that the floor mounted dip switch for high beam someone had fitted had zapped itself.
84 Rangie, 3 inch spring lift, 2 inch body, Megasquirted 4.6, R380, rear Maxi, 34x11.5 JT2s. Simex FM installed.
Who is online
Users browsing this forum: No registered users and 0 guests