Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
P76 megasquirt EFI vid
Moderator: Micka
P76 megasquirt EFI vid
http://www.youtube.com/watch?v=AP5RdzN4n80
Didn't cost much but it was heaps of work[img][img]http://img45.imageshack.us/img45/3269/efimanifold2zr6.jpg[/img][/img]
Didn't cost much but it was heaps of work[img][img]http://img45.imageshack.us/img45/3269/efimanifold2zr6.jpg[/img][/img]
76 2door, 4speed, airlocker front + rear, 4.4, megasquirt efi+ignition.
76 2Door (The Green One), C4 LPG
76 2Door (The Green One), C4 LPG
Yep, I'm stoked it pulls preaty hard with heaps of bottom end torque.
A joy to tune once I got the megasquirt sorted.
picture's worth a thousand words.
back marking onto perspex
marking onto spacer
measuring angle
drilling holes
mounting spacers on lathe turret
cutting reliefs with end mill in a lathe
jigsawing ports
bandsawing manifold
removing manifold webs
match porting to the heads
checing fit on jig eng
welded while bolted to jig eng
match porting to manifold
it pulled a bit when welded, had to get int cleaned up on a mill
no gasket on valley cover
leyand block and heads rover timing case etc
buick hei distributor
A joy to tune once I got the megasquirt sorted.
picture's worth a thousand words.
back marking onto perspex
marking onto spacer
measuring angle
drilling holes
mounting spacers on lathe turret
cutting reliefs with end mill in a lathe
jigsawing ports
bandsawing manifold
removing manifold webs
match porting to the heads
checing fit on jig eng
welded while bolted to jig eng
match porting to manifold
it pulled a bit when welded, had to get int cleaned up on a mill
no gasket on valley cover
leyand block and heads rover timing case etc
buick hei distributor
76 2door, 4speed, airlocker front + rear, 4.4, megasquirt efi+ignition.
76 2Door (The Green One), C4 LPG
76 2Door (The Green One), C4 LPG
it's all here
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=14921
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=14921
76 2door, 4speed, airlocker front + rear, 4.4, megasquirt efi+ignition.
76 2Door (The Green One), C4 LPG
76 2Door (The Green One), C4 LPG
Thanks. Corrected the link to suit the new file structure here:Euan wrote:it's all here
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=14921
http://outerlimits4x4.com/viewtopic.php?t=14921
This is not legal advice.
Who is online
Users browsing this forum: No registered users and 26 guests