Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
engine rough on idle - 4.5l cruiser pertol/gas
Moderators: toaddog, Elmo, DUDELUX
engine rough on idle - 4.5l cruiser pertol/gas
gday lads,
i recently aquired a 94 cruiser 4.5l pertol/gas, auto.
when i start her up she idles fine but after she warms up a bit start idling ruff and the revs drop from about 750-1000rpm to 250 - 500rpm but drives fine... ?
any ideas????? economy's through the roof also
i recently aquired a 94 cruiser 4.5l pertol/gas, auto.
when i start her up she idles fine but after she warms up a bit start idling ruff and the revs drop from about 750-1000rpm to 250 - 500rpm but drives fine... ?
any ideas????? economy's through the roof also
the bellows that are infront of the throttle body split underneath....results in lean mix when hot....good news all plugs looked thesamefaded gxl wrote:havent had the car for 40,000kms yet so no, i havent checked the valve clearance yet... will do tho, plugs werent that bad, all were the same colour,cranks over fine... is there any specific spot in the intake tht is prone to air leaks or is that something i'l just have to have a close look at???
Exhaust valves will be tight no doubt. Set then above the spec of .25 to .35 set them at .40mm as LPG burns hotter the valve grows more and effectivly becomes tight, the valve dosent spend sufficient time on the seat where the heat from the valve is dissapated to the valve seat. Valve and seat failure will occur if the clearance isnt maintained.
Joel
Joel
-Pre trip inspections/ servicing
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
-Suspension/ custom modifications
-4wd Dyno & tuning
-Qualified mechanics
Who is online
Users browsing this forum: No registered users and 5 guests