Hi,
Can anyone confirm that an L300 85 SD front diff is the same as an early Pajero? It appears the same just looking at it and I assume it is 7.25"
Are ring and pinion sets genuine mitsubishi only or are there aftermarket suppliers?
Regards, Al
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
ring and pinion
Moderator: -Scott-
ratios
I have 4.875 now.
I want to fit a 9" rear and the common ratios here are 4.9 and 4.636. I will buy a L200/Triton rear end.
4.625 in a 7.25" is fairly common in early Pajero/Raider so that should not be too hard to get. It would be so close to the 4.636 that I could live with the wind up, equivalent to about 1 mm rolling radius on 31s.
If I could get an 11 tooth pinion and 51 tooth ring (4.636) for the 7.25" low pinion then that would be ideal.
Thanks, Al
I want to fit a 9" rear and the common ratios here are 4.9 and 4.636. I will buy a L200/Triton rear end.
4.625 in a 7.25" is fairly common in early Pajero/Raider so that should not be too hard to get. It would be so close to the 4.636 that I could live with the wind up, equivalent to about 1 mm rolling radius on 31s.
If I could get an 11 tooth pinion and 51 tooth ring (4.636) for the 7.25" low pinion then that would be ideal.
Thanks, Al
Who is online
Users browsing this forum: No registered users and 32 guests