A few of us are heading down to Tassie early next year & to be on the safe side, we will all be taking a good range of spares, including CV's.
My question is, should I get one from Mitsubishi, or would an aftermarket one be OK? If the aftermarket, any suggestions & where can I get one & what ball park figure re, $$$$. I am in Melb, eastern suburbs.
BTW, have a NL.
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
CV's.
Moderator: -Scott-
DON'T GET AFTERMARKET CV'S
Get second hand from the wreckers, There are two sizes for 2nd gen pajero's but they (the whole assy ie one side) both fit on any Gen 2.
If you can get the larger spline ones as they are slightly stronger. The last of the Gen 2 had the smaller spline cv's fitted. Also usually the left hand side goes first.
Regards Glenn
Get second hand from the wreckers, There are two sizes for 2nd gen pajero's but they (the whole assy ie one side) both fit on any Gen 2.
If you can get the larger spline ones as they are slightly stronger. The last of the Gen 2 had the smaller spline cv's fitted. Also usually the left hand side goes first.
Regards Glenn
Pajero GLX 2.8td 255/85/16 BFG muds 265/75/16 BFG AT's, articulator, 2.5inch lift, ball joint flip, rear sway bar disconnect and lots of mods.
Who is online
Users browsing this forum: No registered users and 7 guests